Schneider Engineering brings its unique utility experience to provide reliable engineering solutions to large, industrial Clients with medium and high voltage power needs.  Our team provides solutions to meet increasing availability and reliability demands of the industrial market today.  Our project management, engineering, and construction management experience and methodologies are efficient in providing traditional design-build, or various EPC delivery systems, to meet the needs of our Clients and project types.

Sample projects are shown below for your information.  Browse our Services page or contact us at 830.249.3887 for more information.


FEATURED PROJECTS

Image not available

COLORADO COUNTY, TX | 2015

Schneider Engineering also provided turn-key EPC services for the GSU step-up substation for this plant. The substation included all structural steel, aluminum bus work, and 145kV disconnect switches necessary to connect two 13.8kV-138kV, 30/40/50 MVA power transformers to a 138kV substation.

SCOPE

Schneider Engineering's scope of work included: Owner's Engineer for the complete generation plant, station design, protection and control, construction coordination and inspection, ERCOT filings, and coordinating commissioning.

Schneider Engineering served as Owner's Engineer for this project consisting of six GE Jenbacher 8.75 mW reciprocating engine generator sets. We provided advice and consultation to this Client, reviewed design and engineering of major equipment suppliers and engineering/construction contractor, and performed construction inspection and commissioning coordination.

Image not available

MARTIN COUNTY, TX | 2013

Schneider Engineering provided turn-key engineering services as a member of the EPC teams for this large substation. The substation included two 138kV-4160V, 24 MVA power transformers built to feed a new cryogenic plant and one 138-22kV, 15kV transformer that was needed to support an existing gas plant. The substation also included four 138kV gas circuit switchers, two 138-4160V, 24 MVA power transformers, three 25kV vacuum circuit breakers, a 5kV switchgear line-up with 11 vacuum breakers, arc-flash protected, and tree capacitor banks for power factor correction.

SCOPE

Schneider Engineering's scope of work included: Station design, relay and control design, construction bidding and contracting, construction coordination and inspection, routine site visits, and project close-out and certification.

Image not available

KINNEY COUNTY, TX | 2013

Schneider Engineering provided turn-key engineering services as a member of the EPC team for this large wind generation project.

The project included 55 Vesta V100 (1.815 MW) wind turbine generators. The project provided interconnection to the power grid via a 6.0 mile long radial line. The substation included a 138kV gas circuit breaker, 140 MVA power transformer, two feeder 34.5kV vacuum breakers, one 34.5 kV VCB for protection of the reactive compensation bank, two 8.1 MVAR capacitor banks, one 10 MVAR DSTATCOM to meet power factor requirements, and control house.

The project included 55 Vesta V100 (1.815 MW) wind turbine generators. The project provided interconnection to the power grid via a 6.0 mile long radial line. The substation included a 138kV gas circuit breaker, 140 MVA power transformer, two feeder 34.5kV vacuum breakers, one 34.5 kV VCB for protection of the reactive compensation bank, two 8.1 MVAR capacitor banks, one 10 MVAR DSTATCOM to meet power factor requirements, and control house.

SCOPE

Schneider Engineering's scope of work included: Station and wind farm design, relay and control design, construction bidding and contracting, construction coordination and inspection, routine site visits, and project close-out and certification. Schneider Engineering also provided coordination and review of engineering studies conducted to determine load flow, short circuit, reactive compensation, harmonics, Arc Flash, transient over-voltage, insulation coordination, cable ratings, and energy loss.